Despatch 1500 Controller - Manual (Page 25)

Despatch/Watlow 1500 Control Instruction Manual Page 19
Step
FUNCTION
Display Programming Procedure
Channel 1
Set Point S1 1.
2. Select the Channel 1 set point.
Press ENTER (or FCTN to leave blank).
Channel 2
Set Point S2 1.
2. Select the Channel 2 set point.
Press ENTER (or FCTN to leave blank).
Channel 1
Event
Outputs E1 1.
2.
Select a 1 or a 0 for each of the four available events
(1 = ON, 0 = OFF). The DATA display shows the 1 or 0
entry for Events 4* through 1, from left to right.
Press ENTER (or FCTN to leave blank).
Channel 2
Event
Outputs E2 1.
2.
Select a 1 or a 0 for each of the four available events
(1 = ON, 0 = OFF). The DATA display shows the 1 or 0
entry for Events 4* through 1, from left to right.
Press ENTER.
NOTE:
If you've set DIP Switch #1 ON, then there are only three events
available for each channel. In that case each Event 4 is an
alarm.
Step
Duration HR 1.
2.
3.
4.
5.
6.
Select hours.
Press ENTER. The prompt MN will appear.
Select minutes, press ENTER. The prompt SC will appear.
Select seconds.
Press ENTER. The step duration in hours, minutes and
seconds will appear in the FUNCTION and DATA displays.
The TIME LED will be ON.
Press FCTN to proceed to the next prompt, NX.
Next Step NX To display the next prompt in sequence, press ENTER.
To display a different step:
1.
2.
Enter that step number with the > and ? keys.
Press ENTER. The Watlow 1500 will return to the SP, JL,
WT, NX loop. The process begins over again.
Table 7 Set Point Step Programming Detail
Creating Files/Profiles (Cont.)