Dascom T2150S Quick Start Guide Cutter Option - Manual (Page 8)

Installation Quick start guide
4
` Installing the cut device
Make sure that the printer is switched off before beginning to install the cut device.
Insert the cut device in such a way that the pin c on the right
side slides into the corresponding recess d .
Move down the left side of the cut device, so that the pin e
on the left side slides downwards into the slot f as far as it
will go.
The pin e must be completeley at the bottom of the
slot f .
STOP
d
c
f
e
STOP
Cutter-en.book Seite 4 Donnerstag, 3. Mai 2007 9:42 09