Dascom T2150S Quick Start Guide Cutter Option - Manual (Page 16)

Handling and settings Quick start guide
12
Press the Adjust key.
Press the Cut key.
Set the desired cutting position by pressing the < or > key. You can select a value
between -99/72" (cutting position up) and +98/72" (cutting position down); 1/72"
is equivalent to approx. 0.35 mm.
Confirm the input by pressing the Set key.
Press the Setup or the Online key. The printer changes back to the initial status.
The selected value will be retained after switching off the printer.
` Cutting paper If the automatic cutting function has been deactivated in the AutoCut parameter
group in the menu, or if the Auto View position has been selected (see Additional
menu parameter), the paper must be cut manually after each printout.
Ensure that the printer is in Online status.
Press the Cut key. The printer feeds the paper to the cutting position and cuts it.
Adjust Paperway
Menu Char Online
Setup
2 1 3 4
TOF
Head Cut Online
Setup
2 1 3 4
CutAdj= 00/72" *
Set < > Exit Online
Setup
2 1 3 4
Online Tractor1
Cut Online
Setup
2 1 3 4
Cutter-en.book Seite 12 Donnerstag, 3. Mai 2007 9:42 09