Dascom T2150S Quick Start Guide Cutter Option - Manual (Page 20)

Additional programming sequence Quick start guide
16
Additional programming sequence
With the cut device installed, an escape sequence for cutting at the current line is
available in addition to the programming sequences described in the optionally
available Programming Manual.
Data structure
ASCII ESC ,,[ ,,{
hex 1B 5B n 7B
dec. 27 91 n 123
Parameters
For the ESC [ n { function, the following parameters are available for n:
Cutting single sheets is not possible. Refer to the programming manuals for more
details on the programming sequences.
n hex. dez. Paper source and cut
0 30 48 Single sheet (manually)
5 35 53 Fanfold paper tractor 1
6 36 54 Fanfold paper tractor 2
7 37 55 Fanfold paper tractor 3
22 32 32 50 50 Fanfold paper ASF-F
50 35 30 53 48 Return sheet to the printing position
51 35 31 53 49 Cut fanfold paper at next perforation
54 35 34 53 52 Cut above/below the current line*
* Above the line if the text to be printed ends with a CR (hex. 0D, dec. 13).
Below the line if the text to be printed ends with a LF (hex. 0A, dec. 10).
Cutter-en.book Seite 16 Donnerstag, 3. Mai 2007 9:42 09