Dascom T2150S Quick Start Guide Cutter Option - Manual (Page 12)

Handling and settings Quick start guide
8
Handling and settings
` Changing the paper type The printer is able to process either single sheets or fanfold paper. Only fanfold
paper can be cutted. If the printer is set for single-sheet mode, you will need to
change the paper type.
This example shows how to select tractor 1 (the recommended paper source). You
can select tractor 2 or tractor 3 in the same way. We recommend to use only one
tractor since the cutting position may change when the paper source is changed.
Ensure that the printer is in Offline status; press the Online key, if necessary.
Press the Park key.
If a single sheet is loaded in the printer, it will be ejected.
Press the Tractor1 key.
If you do not make a selection within 5 seconds, the printer exits the menu without
a change.
The printer changes back to Offline status and the display alternates between…
and…
Press the Online key.
Offline Single
Park Load
Online
Setup
2 1 3 4
Single Tractor1
Online
Setup
ASF-R Next
2 1 3 4
Load paper from
Tractor1
Online
Setup
2 1 3 4
Offline
Park Load
Online
Setup
2 1 3 4
Cutter-en.book Seite 8 Donnerstag, 3. Mai 2007 9:42 09