Dascom T2150S Quick Start Guide Cutter Option - Manual (Page 18)

Handling and settings Quick start guide
14
Press the < (2) or > (3) key to switch the parameter to On. Confirm the setting by
pressing the Set (1) key.
If you use paper without the required label on the back after activating the param-
eter Sync.Label, an error message Load error appears in the display, printing is
not possible.
If the printer cannot detect an existing label on the back of the paper, the param-
eter Pap.back can in test mode be set from “normal” to “dark”. You will find a
description of this parameter in the user guide of your printer on the online CD-
ROM.
You must deactivate this parameter before removing the cut device. It only appears
in the test menu when the cut device is installed and therefore cannot be switched
off after removing the cut device, but remains active.
Sync.Label=Off *
Set < > Exit Online
Setup
2 1 3 4
STOP
Cutter-en.book Seite 14 Donnerstag, 3. Mai 2007 9:42 09