Dascom LA650+ Quick Start Guide - Manual (Page 9)

Quick start guide Installation
7
ENGLISH
` Placing your printer
Place the printer on a solid, flat, surface, ensuring that the printer is positioned in
such a way that it can not topple, and that there is easy access to the control panel
and paper input devices. Also ensure that there is sufficient space for the printed
output.
If you expect that frequent forward and reverse feeds will oc-
cur, you should place the printer as shown in the figure, if
possible.
The power supply cable may be damaged if the pa-
per edges constantly chafe the insulating sheath.
The user must always ensure that there is sufficient
distance between the power supply cable and the
paper.
When selecting the printer location, observe the following additional instructions:
Never place the printer in the vicinity of inflammable gas or explosive substances.
„ Do not expose the printer to direct sunlight. If you cannot avoid placing the
printer near a window, protect it from the sunlight with a curtain.
„ When connecting a computer to the printer, make sure not to exceed the maxi-
mum cable length (see User guide on the Online CD-ROM, Technical Specifi-
cations).
„ Ensure sufficient distance between the printer and any heating devices/radia-
tors.
„ Avoid exposing the printer to extreme temperature or air humidity fluctuations.
Above all take care to avoid the influence of dust.
„ It is recommended to install the printer in a place which is acoustically isolated
from the workplace because of the noise it may produce.
STOP
STOP
Quick Start-en.book Seite 7 Freitag, 16. Oktober 2009 1:20 13