Dascom LA650+ Quick Start Guide - Manual (Page 20)

Paper handling Quick start guide
18
Paper handling
This section describes how to set the paper type, load fanfold paper and single
sheets, transport paper and move the paper to the tear position.
` Changing the paper type
You can change the paper type either from an application program, by means of
the paper path quick selection feature or in the Setup menu. In this section, the
quick selection feature is described; for detailed information on how to make this
setting via the Setup menu, see “Changing the paper type in the Setup menu”,
page 19.
On some printer models, the single sheet paper source cannot be selected since
these models are not designed for manual single sheet feeding.
Make sure that the printer is in offline mode (Pause); press the Online key, if nec-
essary.
Press the Park (1) key. If fanfold paper is loaded in the printer, it is fed to the tear
position. The text
Tear paper off appears in the display. After having torn off the
paper, press any key. If a single sheet is loaded in the printer, it is ejected.
Use one of the marked keys to select the desired paper path, for example,
Single (2).
The display shown here may vary according to the chosen paper options.
If you do not make a selection within 5 seconds, the menu is closed.
The printer returns to offline mode. The display alternates between the basic menu
and the menu in the following figure:
Insert a single sheet (for the procedure, see “Single sheets”, page 23).
Pause Front1
Park LF/FF Online
Setup
2 1 3 4
Single Front1
Online
Setup
2 1 3 4
Load paper from
Single Online
Setup
2 1 3 4
Quick Start-en.book Seite 18 Freitag, 16. Oktober 2009 1:20 13