Traceable logger-trac instructions – Control Company 6540 TRACEABLE LOGGER-TRAC User Manual

Page 2

• User Stop Key Enable – This feature allows the user to

halt data recording by holding down the START button

on the device once recording is started.

HOW TO START THE DATA LOGGER

1. When ready to begin recording, press and hold the

START button for 5 seconds on the front panel. The

LCD will become active and display the current tem-

perature as well as the REC symbol to indicate logging

is now active.

2. Place thermometer in environment to begin monitoring.
HOW TO STOP THE DATA LOGGER

1. User may stop the thermometer logging by pressing

and holding the START button for 3 seconds. The LCD

will display the word END once logging is stopped.

The logging can also be stopped in advance of the

preprogrammed logging duration time by plugging the

thermometer into the USB cradle (not included) and

selecting Stop under the Logger Menu in MaxiThermal

software (not included). Once the device has been

stopped, the user may download the logged data from

the thermometer.

2. Logging cannot be restarted until the thermometer has

been reinitialized using MaxiThermal. Pressing START

will not reactive the unit.

HOW TO REPLACE BATTERY

On back the Data Logger, turn the round plate counter-

clockwise, and replace with a new CR2016 3V Lithium Coin

Cell battery. Turn the plate clockwise to lock.

WARRANTY, SERVICE, OR RECALIBRATION

For warranty, service, or recalibration, contact:

CONTROL COMPANY

4455 Rex Road

Friendswood, Texas 77546 USA

Ph. 281 482-1714 • Fax 281 482-9448

E-mail [email protected] • www.control3.com

Control Company is ISO 9001 Quality-Certified by DNV and

ISO 17025 accredited as a Calibration Laboratory by A2LA.

TRACEABLE

LOGGER-TRAC

INSTRUCTIONS

™

Control Company Cat. No. 6540

Traceable

is a registered trademark of Control Company.