Control Company 5200 WATERPROOF COUNTDOWN TIMER - Manual

SPECIFICATIONS
Timing capacity: 99 minutes 59 seconds.
Battery: silver-oxide button cell
COUNT-UP TIMING
The unit counts up to 99 minutes 59 seconds. Once the
timer reaches 99 minutes 59 seconds it starts the timing
over again from 00 minutes 00 seconds.
COUNTDOWN ALARM TIMING
1. Press the MIN and SEC buttons simultaneously to
clear the display to zero.
2. Press the MIN (minutes) button to advance the
minutes digits. Press and hold down the MIN
button to rapidly advance the minutes.
3. Press the SEC (seconds) button to advance the
seconds digits. Press and hold down the SEC
button to rapidly advance the seconds.
4. Once the desired time is on the display, press the
START/STOP button to begin countdown timing.
5. When the timer reaches zero, an alarm will sound.
The alarm will sound for one minute and then turn off
automatically to preserve battery life.
While the alarm is sounding, pressing the START/STOP
button will silence the alarm, stop the count-up timing,
and recall the last programmed time. After one minute,
pressing the START/STOP button will stop the count-up
timing and recall the last programmed time.
MEMORY RECALL
When timing repetitive intervals, the memory function
will recall the last programmed time. This feature
allows the timer to be dedicated to a frequently timed
test. The timer will return to the last programmed time
again and again.
1. Follow steps 1 through 5 in the “Countdown Alarm
Timing” section.
2. When the alarm starts, press the START/STOP
button to stop the alarm and recall the last
programmed time.
3. Press the START/STOP button a again to begin
countdown timing.
CLEARING THE DISPLAY TO ZERO
If an error is made during an entry, press the MIN and
SEC buttons simultaneously to clear the display to zero.
To clear the display to zero when time is running, press
the MIN and SEC buttons simultaneously.
STOPWATCH (COUNT-UP) TIMING
1. Clear the display to zero (simultaneously press
the MIN and SEC buttons).
2. Press the START/STOP button to begin count-up
timing.
3. Press the START/STOP button to stop count-
up timing.
Once timing is completed and the timer has stopped,
press the MIN and SEC buttons simultaneously to clear
the display to zero.
TIMEOUT
The timer may be started or stopped during any running
time by pressing the START/STOP button.
CONVERT A TIMEOUT TO A COUNTDOWN TIME
Once the timing has been stopped, pressing the MIN
or SEC button will increment the display from the point
that it was stopped and will set the timer into countdown
mode. Once the desired time is on the display, press the
START/STOP button to begin countdown timing.