Control Company 5125 WORKSTATION–TRACEABLE RADIO-CONTROLLED CLOCK - Manual (Page 2)

SILENCING THE TIME-OF-DAY ALARM
When the time-of-day alarm sounds, it will gradually increase in volume and intensity.
If the alarm is not silenced manually, it will sound for one minute, silence automatically
and will sound again the following day.
The alarm may be silenced manually in the following ways:
When in alarm mode (indicated by  appearing on the display), pressing any button
will silence the alarm. The alarm will sound again the following day.
When in the snooze alarm mode (indicated by Z Z  appearing on the display),
pressing the SNOOZE button will activate the snooze feature, (Z Z  flashing indicates
that the snooze feature has been activated). The alarm will sound again after eight (8)
minutes. The snooze feature may be used as many times as desired. To discontinue
the snooze feature, press any button (other than SNOOZE) to silence the alarm. The
alarm will sound again the following day.
DISPLAY BACKLIGHT
To view the display in dim or dark conditions, press the SNOOZE button to activate the
display backlight.
MANUALLY INITIATING SIGNAL RECEPTION
If you have moved the unit from a location where it was receiving a strong complete
signal, it is recommended that you manually initial signal reception to insure that the
unit will receive a complete signal in its new location.
To manually initiate signal reception:
Press and release the
+ button until appears on the display, indicating that the unit is
attempting to receive the signal from the Atomic Clock.
ALL OPERATIONAL DIFFICULTIES
If this unit does not function properly for any reason, replace the battery with a new
high quality battery (see “Battery Replacement” section). Low battery power can
occasionally cause any number of “apparent” operational difficulties. Replacing the
battery with a new fresh battery will solve most difficulties.
BATTERY REPLACEMENT
Erratic readings, faint readings, or no display are all indications that the battery must
be replaced. Remove the battery cover. Remove the exhausted battery and replace
with a new AA alkaline battery. Replace the battery cover. Upon initial installation of
the battery, the unit automatically initiates signal reception. (See the “Operation”
section for more details.)
Warranty, Service, or Recalibration
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714
Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-Certified by
DNV and ISO 17025 accredited as a Calibration
Laboratory by A2LA.
Control Company Cat. No. 5125
Traceable
® is a registered trademark of Control Company
© 2007 Control Company