Traceable countdown controller instructions, Control company – Control Company 5095 COUNTDOWN CONTROLLER User Manual

Page 2

AUTO-RETURN TO CLOCK DISPLAY

If the unit is left idling more than 1 minute during

programming or displaying another mode, the display

will return to clock and the programming operation is

cancelled. However, if the display is showing count down

time in progress, auto-return will riot activate until count

down is finished.
LED INDICATOR

The LED indicator shows the status of the timer. If the

LED is lit, the timer is on and if the LED is not lit, the timer

is off. Note that the timer’s status can also be seen in the

CLOCK mode, by the word ON or OFF. The LED will only

light when the timer is plugged into an electrical outlet.
RESET

The RESET key is located on the top-right hand corner

of the function board. Use a round object such as a

ball-point pen to push the reset key while the SET key

is pressed. Then release the RESET key first before the

SET key. After reset, all preset programs are erased from

timer’s memories.
ABNORMAL DISPLAY

When an abnormal display or a blank display appears on

the timer, use the above Reset procedure, otherwise the

timer may not work properly. Be sure that the recharge-

able battery Is adequately charged.

WARRANTY, SERVICE, OR
RECALIBRATION
For warranty, service, or recalibration, contact:

CONTROL COMPANY

4455 Rex Road

Friendswood, Texas 77546 USA

Ph. 281 482-1714

Fax 281 482-9448

www.control3.com

Control Company is ISO 9001

Quality-Certified by DNV and

ISO 17025 accredited as a

Calibration Laboratory by A2LA.

TRACEABLE

COUNTDOWN

CONTROLLER

INSTRUCTIONS

Control Company

. 92-5095-00 Rev. 3 060214

Traceable

is a registered trademark of Control Company.