Control company – Control Company 5040 100-HOUR TIMER User Manual

Page 2

2. Two channels count up, two channels count down. (Clear T1 and T2 to

00:00 00, set T3 and T4. Press and hold ENTER, then press
START/STOP.)

3. Three channels count up, one channel counts down. (Clear T1, T2, and

T3 to 00:00 00, set T4. Press and hold ENTER, then press
START/STOP.)

CHANGING MODES
During any timing event, SELECTOR SWITCH may by moved to any desired
position without affecting timing functions in other modes.
ALL OPERATIONAL DIFFICULTIES
If this timer does not function properly for any reason, please replace battery
with a new, high-quality battery (see “Battery Replacement” section). Low
battery power can occasionally cause any number of “apparent” operational

difficulties. Replacing battery with a fresh new battery will solve most
difficulties.
BATTERY REPLACEMENT
An incorrect display, no display, or operational difficulties indicate that battery
should be replaced. Use a coin to open battery cover on back of timer (turn
cover approximately ⅛ of a turn counter-clockwise). Insert battery with
positive (+) side facing up. Replace battery cover. Replacement battery Cat.
No. 1039.

Warranty, Service, or Recalibration
For warranty, service, or recalibration, contact:

CONTROL COMPANY

4455 Rex Road

Friendswood, Texas 77546 USA

Ph. 281-482-1714

Fax 281-482-9448

E-mail [email protected]

www.control3.com

Control Company is ISO 9001 Quality-Certified by DNV and ISO 17025 accredited as a Calibration

Laboratory by A2LA.

Control Company Cat. No. 5040. Rev. 2 032907
Traceable

is a registered trademark of Control Company