Barranca Diamond BD10 Power Feed Trim Saw User Manual

Page 16

Fig. 22. Manual feed position

Fig. 23. Loosen vise

Fig. 24. Rotate vise up

TRIM SAWING MODE

Slabbing of rock material to uniform thicknesses using the BD10 Trim Saw is best performed using the auto-

matic power feed mode. However, manual trimming of slabs to desired shapes (preforming) can be achieved

using the saw in the LEFT/MANUAL FEED position (Fig. 22).

To use this mode, first place the toggle in the MIDDLE/OFF position (Fig. 9) and flip the vise assembly over the

cross feed rail by removing the knob on hinged portion of the vise (Fig. 23) and rotating the vise so that it pivots

off the saw table (Fig. 24). At this point the saw is ready to be used in the manual mode (with only the blade

motor activated) for manual trimming of slabs by placing the toggle in the LEFT/MANUAL FEED position.

BD10

OPERATIONS AND ADJUSTMENTS