Atop Technology MB5416A2 User manual - Manual (Page 33)

Atop Modbus Gateway
MB54XX-X Series
User’s Manual V 1.1
30
3.5.5 TCP Settings
Settings for representing a Modbus TCP connection using the internet are set here. First go
to Basic Settings ↔ TCP Settings, then proceed to choose whether to enable TCP ticking on
the “Enable” box.
Fig. 3. 14
 TCP Slave: When on this mode, the device will run on Slave mode and wait to receive
Modbus requests from the Master; data transmission is done under a Modbus TCP
format.
 Remote IP Address shows the device ’s slave node IP address.
 TCP Port shows the device ’s slave node TCP port.
 VCOM inactivity’s Time Out can be set as well (which is the period of time allowed
between actions), with a maximum of 600 minutes or 10 hours. If no action has been
taken after this period, Modbus TCP connection will be automatically terminated by the
system.