Atop Technology MB5416A2 User manual - Manual (Page 23)

Atop Modbus Gateway
MB54XX-X Series
User’s Manual V 1.1
20
 To enter: 3. Net mask Use / to increase or decrease the Digital of
subnet mask and then
 To enter: 4. Gateway. Use / to increase the Digital of default gateway
and use
 Press to the end of the menu to return to one level higher and the device shall
display System message “Save & Restart”. Push to 2. Yes, and
again after completion. The device shall restart and the new settings will appear.
The LCM command structure is as follows, Table.
Table 3. 2
1
st
layer 2
nd
layer 3rd layer 4
th
layer 5
th
layer Descriptions
1.Overview
1. Model name Display Model name
2. Kernel ver. Display kernel version
3. AP ver. Display AP version
4. Lan 1
1.Lan status Display status of LAN1
2.MAC Display MAC address of LAN1
5. Lan 2
1.Lan status Display LAN of LAN2
2.MAC Display MAC address of LAN2
2.Network set
1.Lan 1
1.IP config
1.Static IP Display/Change static IP
2.DHCP
Display dynamic IP or enable
DHCP
2.IP address Display/Change LAN1 IP
3.Net mask Display/ Change Net mask
4.Gateway Display/Change the Gateway IP
2.DNS server1
Display or Change 1st DNS IP
address
3.DNS server2
Display or Change 2nd DNS IP
address
3.Serial set 1.Select port
Select COM Port: SE5016:
[1]~[16] / SE5008: [1]~[8]