5 com1 setup, 6 exit with save and reset, 7 exit with save and reset – Atop Technology MB5001C User Manual User Manual

Page 14: 8 link 1 setup

User Manual Version 1.0

MB5001C series 1-port Modbus Gateway

3.2.5 COM1 Setup

Select “5” from “Input choice and enter (1~8,a~f):” to Setup COM1. One can then give the COM port alias
name, set the baud rate and parity, determine number of data bit and stop bit, and decide if one want to use
flow control and the type of flow control one want to use. The following screen (Figure 3.10) illustrates how to
setup 9600 baudrate, none parity, 8 data bits, and 1 stop bit.

Figure 3.10 COM1 Setup

3.2.6 Exit with Save and Reset

Select “7” from “Input choice and enter (1~8,a~f):” to Exit with Save. Please choose this option to save all
the previous changes to EEPROM, the device will restart automatically.

3.2.7 Exit with Save and Reset

Select “8” from “Input choice and enter (1~8,a~f):” to Exit with Save. Please choose this option to discard
all the previous changes the device will close telnet connection automatically.

3.2.8 Link 1 Setup

Select “a” from “Input choice and enter (1~8,a~f):” to Exit with Save. The following screen (Figure 3.11)
illustrates how to set port to 502, connection to 2, input timeout to 400, protocol to ASCII, and retry to 2
times.