2 configuration by telnet utility, 1 login to the system – Atop Technology MB5001C User Manual User Manual
Page 12
User Manual Version 1.0
MB5001C series 1-port Modbus Gateway
Copyright © 2010 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan.
11
3.2 Configuration by Telnet Utility
One can use Telnet utility to change configuration settings of MB5001C by following steps：
3.2.1 Login to the System
->Open Ms-DOS command prompt window
->Telnet to MB5001C
using command “Telnet IP_address”.( For example：Input Telnet 10.0.50.100 in
Ms-DOS command prompt window).After telnet to MB5001C, system prompts for a password, the default
password is left it blank. (Figure 3.4)
Figure 3.4 Login to the system
Note: One can press the default button of MB5001C to reset the password to the default value.
1. After verifying the password, the following terminal screen appears.( Figure 3.5)
Figure 3.5 Main menu
Note: Changes to networking parameters will take effect only when one exit and restart MB5001C.
->Select
“1” from “Input choice and enter (1~8,a~f):” to enter show configuration page as
following:( Figure 3.6)