Anchor NAVI-TRAC LITE 20 WIDE - Manual (Page 17)

Gabled End Frame Assembly
If the End Upright was not installed to the Gabled End Weldment
while the end beam was on the ground, it will have to be installed
from a ladder. (See fig. 44 for correct installation of the End Rafter
Fittings).
Next, install the hooked bar end connector of the wing eave bar into
the corner upright bracket (fig. 45). Then, drop in the angled end
on the remaining bracket of the end upright (fig. 46). Repeat this
process for the opposite end wing eave bar, then stake down the
uprights.
45
46
47
48
Installation of Gabled End
Fabric Panels
To install the gabled end fabric, first insert one of the wheeled panel
guides and bracket on the end beam with the wheels facing out.
Insert the fabric kedar of one half the end into the upper channel
and use the push pole to slide the half panel to the peak (fig. 47).
Repeat this from the other side of the structure. Then join the two
half panels at the peak using the carabiner to fasten the rings and
lace down the center line using a standard loop and grommet tent
lacing pattern.
Attach the web ratchet to the triangular metal ring and to the tension
hole in the end upright and ratchet into tension (fig. 48).
GU
WR
GABLED END
VALANCE
RIGHT
SIDE
LEFT
SIDE
STANDARD LOOP &
GROMMET LACE WITH
WEATHER FLAP.
17