AirLive RS-2000 - Manual (Page 168)

１６７
Modifying the Virtual Server configurations
Step 1.
In the Virtual Server window’s service table, locate the name of the service
desired to be modified and click its corresponding Modify option in the Configure
field.
Step 2.
In the Virtual Server Configuration window, enter the new settings.
Step 3.
Click OK to save modifications or click Cancel to discard changes.
WAN：Enter the WAN IP address that configured by the virtual server.
Server Virtual IP：Enter the WAN IP address configured by the virtual server.
Service Name (Port)：Click the pull-down menu the system will display you the service item
port.
WAN Service Port：The WAN Service Port that provided by the virtual server.
Service Name：The service names that provided by the virtual server.
LAN Server IP：The LAN server IP address mapped by the virtual server. Four computer IP
addresses can be set at most, and the load can be maintained in a balance.Click OK to
execute the change of the virtual server, or click Cancel to discard changes.
If the destination Network in Policy has set a virtual server, it will not be able to change
or configure this virtual server, you have to remove this configuration of Policy, and then you
can execute the modification or configuration.