AirLive RS-2000 - Manual (Page 167)

１６６
Adding New Virtual Server Service Configuration
Step 1.
Select Virtual Server in the menu bar on the left hand side, and then select Virtual
Server 1/2/3/4 sub-selections.
Step 2.
In Virtual Server 1/2/3/4/3/4 Window, click “Click here to configure” button.
Step 3.
Enter the parameters in the Server Virtual IP column.
WAN：Enter the WAN IP address that configured by the virtual server.
Server Virtual IP：Enter the WAN IP address configured by the virtual server.
Service Name (Port)：Click the pull-down menu the system will display you the service item
port.
WAN Service Port：The WAN Service Port that provided by the virtual server.
Service Name：The service names that provided by the virtual server.
LAN Server IP：The LAN server IP address mapped by the virtual server. Four computer IP
addresses can be set at most, and the load can be maintained in a balance.
Click OK to execute adding new virtual server service, or click Cancel to discard adding.
The administrator can click the “Click here to configure” button in the Virtual Server window
to add the service items of virtual server. Remember to configure the service items of virtual
server before you configure Policy, or the service names will not be shown in Policy.