AirLive POE-GSH2004L-370 - Manual (Page 35)

4. Web Management
 Mode:
Set the speed and duplex of the port. If the media is 1Gbps fiber, there are three modes to
choose: Auto Speed, 1000 Full and Disable. If the media is TP, the Speed/Duplex is
comprised of the combination of speed mode, 10/100/1000Mbps, and duplex mode, full
duplex and half duplex.
In Auto Speed mode, no default value. In Forced mode, default value depends on your
setting.
 Flow Control:
You can Just tick the check box ( ) to enable flow control. If flow control is set Enable, both
parties can send PAUSE frame to the transmitting device(s) if the receiving port is too busy
to handle. When it is set Disable, there will be no flow control in the port. It drops the packet
if too much to handle.
Default: Disable
4.4.3 VLAN Mode Configuration
Web Smart Switch supports Port-based VLAN and Tag-based VLAN (802.1q).
Its VLAN mode supports 10 active VLANs and the available VLAN ID range is from
1~4094. VLAN configuration is used to divide a LAN into smaller ones. With proper
configuration, you can gain not only improved security and increased performance, but also
save a lot of VLAN management effort.
The VLAN Mode Selection function includes two modes: Port-based, Tag-based.
AirLive POE-GSH2004L-370 User’s Manual
30