AirLive POE-GSH2004L-370 User Manual
Page 14
2. Installation of the Switch
For legacy devices that are not yet compatible, the PoE port will not offer the power to
these devices. This feature allows users to freely and safely mix legacy and Power over
Ethernet compatible devices on their network.
Combo SFP Ports (Port 21~24)
The Switch is equipped with four combo SFP ports, supported optional 1000BASE-SX/LX
SFP module. The 1000BASE-T port 21~24 are the same ports with the SFP port 21~24,
when plug in the SFP module, the device will activate SFP, and the RJ45 port will be
disabled.
※
Note: When the port was set to “Forced Mode”, the Auto MDI/MDIX will be disabled.
Mode button:
The Mode button is to change the LED’s status to Link/Act or Speed, and reset all the
setting back to the factory default by pressing the mode button for 10 seconds.
※
Note: Be sure that you recorded the setting of your device; else all the setting will be
erased when pressing the “
Mode” (reset) button 10 seconds.
2.2.2 Rear Panel
The 3-pronged power plug and on/off switch are placed at the rear panel of the switch right
side shown as below.
AirLive POE-GSH2004L-370 User’s Manual
9