AirLive POE-FSH2422G-250 - Manual (Page 7)

1. Introduction
AirLive POE-FSH2422G-250 User’s Manual
2
1.3 Quick Setup
Power-On the switch
„ The POE-FSH2422G-250 Switch has a built-in power supply to operate with 100 ~
240V AC, 50 ~ 60Hz power source.
„ The AC power cord connector is located at the rear of the unit and the On/Off switch is
next to the connector.
„ After the Switch is powered on, it will perform “self-diagnostic” test. This process takes
about 10 seconds to complete.
It is recommended that you install the switch with an UPS to
protect from potential power surge.
The default password is airlive
This switch is using 48V 802.3af PoE standard. It does not
work with passive PoE. Do not connect with passive PoE devices.
The default IP address: 192.168.2.1
The default username is admin
Important Information
LED Table
LED Status Description No. Of LED
Power On Power on Power
On Link 1000Mbps
1000M
Off Link 10/100Mbps
2 (25~26)
On Link 26 (1~26)
Link/ ACT
Flashing Data activating 26 (1~26)
On
Port is linked to Power
Device
24 (1~24)
PoE
Off
No Power Device is
connected
24 (1~24)