AirLive POE-FSH2422G-250 - Manual (Page 12)

2. Installation of the Switch
AirLive POE-FSH2422G-250 User’s Manual 7
2.2 Hardware Overview
Front Panel
The front panel of the web smart switch consists of 24 10/100Base-TX RJ-45 ports and 2
combo gigabit uplink RJ-45/SFP ports. The LED Indicators are also located on the front
panel.
LED Indicators:
Comprehensive LED indicators display the status of the switch and the network (see the
LED Indicators chapter below).
100BASE-TX Fast Ethernet PoE Ports (Port 1~24):
These ports are PoE enable ports. These PoE ports will be automatically activated when a
compatible terminal is identified, and the PoE port will supply power to the connected PoE
device.
For legacy devices that are not yet compatible, the PoE port will not offer the power to
these devices. This feature allows users to freely and safely mix legacy and Power over
Ethernet compatible devices on their network.
These ports support network speeds of either 10Mbps or 100Mbps, and can operate in half-
and full- duplex transfer modes. These ports also support the automatic MDI/MDIX
crossover detection function, providing true “plug and play” capability. Just plug-in the
network cable to the hub directly and regardless if the end node is a NIC (Network Interface
Card) or switch and hub.