AirLive POE-FSH2422G-250 - Manual (Page 17)

2. Installation of the Switch
AirLive POE-FSH2422G-250 User’s Manual
12
The following table summarizes the cable requirement for 10/100/1000BASE-TX
connection:
10BASE-T 100 ohm Category 3, 4, 5 UTP/STP
cable
100BASE-TX 100 ohm Category 5 UTP/STP cable
1000BASE-T 100 ohm Category 5E UTP/STP cable
or better
Auto MDI/MDI-X function
The POE-FSH2422G-250 PoE Switch is equipped with Auto-MDI/MDI-X function, which
allows you to use straight-thru cable even when connecting to another switch/hub. Simply
use the straight-through cable for all types of 10/100BASE-TX connections, either to a PC
or to a networking device such as other hub or switch.
Connection
Specification
10 /100Base-TX and 1000Base-T
Ports
Interface RJ-45
Cable to Use
To an end station Straight-through twisted-pair cable
To a hub/switch Straight-through twisted-pair cable
Maximum Distance 100 meters
2.7 Connecting to Power
POE-FSH2422G-250 PoE Switch features a universal auto-select power supply unit, which
allows a power connection to a wide range of input voltages from 100 to 240VAC @ 50 ~
60Hz.
To establish its power connection, simply plug the female end of the power cord into the power connector on the rear of
the switch and the male end of the power cord into a suitable power outlet. Once you have correctly plugged in the
power, you can then turn on the Power Switch to activate the switch.