AirLive POE-FSH2422G-250 - Manual (Page 13)

2. Installation of the Switch
AirLive POE-FSH2422G-250 User’s Manual
8
1000BASE-T Gigabit Ethernet Ports (Port 25~26):
The Switch provides two Gigabit twisted pair ports, supported auto negotiable
10/100/1000Mbps and auto MDI/MDIX crossover detection function, this function gives true
“plug and play” capability, just need to plug-in the network cable to the hub directly and
don’t care if the end node is NIC (Network Interface Card) or switch and hub. These ports
can operate in half-duplex mode for 10/100Mbps and full- duplex mode for
10/100/1000Mbps.
Note: When the port was set to “Forced Mode”, the Auto MDI/MDIX will be disabled.
Combo mini-GBIC Ports (Port 25~26)
The Switch is equipped with two combo mini-GBIC ports, supported optional
1000BASE-SX/LX mini-GBIC module. The 1000BASE-T port 25 and 26 are the same ports
with the mini-GBIC port 25 and 26, when plug in the mini-GBIC module, the device will
activate mini-GBIC, and the RJ45 port will be disabled.
Reset:
The Reset button is to reset all the setting back to the factory default.
Note: Be sure that you recorded the setting of your device, else all the setting will be erased
when pressing the “Reset” button.
The Rear Panel
The 3-pronged power plug is placed at the rear panel of the switch right side shown as
below.