Warning – AirLive FE-200CU User Manual

Page 44

4. Administrating the Device

AirLive FE-200CU Manual

Firmware Upgrade:
The device supports new firmware upgrade (the software that controls the operation in
the device). Please contact your dealer for the latest version if necessary.

Download the latest firmware file from our website or your dealer. Unzip this
firmware file to binary file and store it into your PC. Then follow the steps as bellows
carefully:

1. Close all other application programs which are not necessary for firmware

update.

2. Make sure that only you access this device while firmware updating.
3. Disable Motion Detection function.
4. Click “Browse” button. Select the Firmware binary file. (

Note that it must

make sure that the Firmware only applies to this device, once update, it will be
burned into FLASH ROM of system.

)

5. Once the firmware file was selected, click “Firmware Upgrade” button.
6. The upgrade progress information will be displayed. Once the uploading

process completed, the device will reboot the system automatically.

7. Please wait for timer countdown, and then you can use IPWizard II to search

the device again.

Warning!!!

The download firmware procedure can not be interrupted. If the power and/or
network connection are broken during the download procedure, it might possibly
cause serious damage to the device.
Strongly suggest that DO NOT upgrade firmware via Wireless LAN due to high error
rate possibly and DO NOT allow any other clients to access this unit during updating
procedure.
Be aware that you should not turn off the power during updating the firmware and wait
for finish message.
Furthermore, the firmware upgrade procedure always is risk and do not try to upgrade
new firmware if it’s not necessary.

Backup Setting:
To take a backup of all of the parameters, click this button. If necessary, it will then
be possible to return to the previous settings.

Upload Setting:
Click the “Browse” button to locate the saved backup file and then click the “Upload
Setting” button. The settings will be restored to the previous configuration.