AirLive FE-200CU - Manual (Page 38)

4. Administrating the Device
AirLive FE-200CU Manual 32
z DHCP Service:
Stand for Dynamic Host Configuration Protocol.
Enable this checked box when a DHCP server is installed on the network to issue IP
address assignment. With this setting, the IP address is assigned automatically. If
this device can not get an IP address within limited tries, the device will assign to the
default IP address, 192.168.1.100, by itself.
z IP address, Subnet mask, and Gateway:
If you do not select Obtain an IP address automatically, then you need to enter these
network parameters manually.
z DNS 1 and DNS2:
If you do not select Obtain DNS from DHCP, then you need to enter these parameters
manually.
Enable this checked box when a DHCP server is installed on the network and provide
DNS service.
z PPPoE:
A standard builds on Ethernet and Point-to-Point network protocol. It allows your
device with xDSL or cable connects with broadband network directly. Then, your
device can dial up and get a dynamic IP address. For more PPPoE and Internet
configuration, please consult your dealer or ISP.