AiM EVO4 - Manual (Page 10)

CHAPTER 3 LINKS, SENSORS AND CONFIGURATIONS
18 1 19 9
System Configuration.
In the following RaceStudio2 page you can
set:
n How RPMs are acquired: from ECU
data stream or reading a digital signal.
n The maximum rpm value.
n The division factor of the engine
revolutions, ie the constant for which to
divide the digital pulses number in order
to obtain the correct value.
Channels Configuration.
In the following RaceStudio2 page you can
define:
n Which channels are enabled.
n The type of sensor connected.
n The sampling frequency.
n The unit of measure.
EVO 4
n How to get the gear number:
by calculation, potentiometer or ECU.
n To use GPS in order to get lap time
n To select a speed signal as Reference
Speed.
n How to manage digital output.