2 operation location, 3 damage caused by improper use, 4 warranty / repair – ADS-TEC IF1000 User Manual

Page 7

IF1000 series

2.2 Operation Location

This device is designed for use in industry. You must ensure compliance with the specified environmental
conditions. Using the device in non‐specified environments, e.g. on board ship or in areas containing explosive
vapours, gases or gas mixes, as well as in extreme heights, is prohibited

Warning:

For the prevention of water condensate accumulation, the unit should be turned ON only
when it reaches ambient temperature. This particularly applies when the unit is subject to
extreme temperature fluctuations and/or variations.

Avoid overheating during unit operations; the unit must not be exposed to direct
sunlight or any other direct light or heat sources.

2.3 Damage Caused By Improper Use

This device must immediately be shut down and protected from any accidental commissioning if the operating
system shows any obvious damage caused by, for example, improper operating or storage conditions, or by
improper use or handling.

2.4 Warranty / Repair

During the warranty period, any repair must only be carried out by the manufacturer or by a person authorised
by the manufacturer.