ADS-TEC IF1000 - Manual (Page 33)

IF1000 series 32
© ads‐tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden‐Echterdingen
5.6 Operational LED Status Displays
5.6.1 Status Display Activities when Booting
Te boot‐up process starts as soon as the firewall is supplied with a voltage source. With the aid of the Lan‐in LEDs
it is possible to check whether the Firewall is booting up as well.
5.6.2 Status display activities when resetting to default settings
Via the Factory Default keys on the rear side of the Firewall it is possible to reset the Firewall back to its default
factory settings at any time, independently of its configuration.
To set the Firewall back to its default settings, the factory default keys must be pressed during current
operations. In the example, no LAN‐in cable / PoE is connected up.
The factory default keys must be pressed once, briefly in order to start the set‐back to default settings process
5.6.3 Status display activities with Firmware Updates
A firmware update can be made by using the web interface. The actual process of updating might take a few
minutes.