ADS-TEC IF1000 User Manual

Page 28

IF1000 series

Device info

Anzeige

Selection

Action

Device info

This option displays general device
information.

The screen shows the name of the
manufacturer, the device variant, whether
a NVRAM card is installed, the current
firmware version, and the current firmware
build.

Device Test

Anzeige

Selction

Action

Screen

Starts the display test.

Press Enter to start the display test.

Perform this test to check the display for
correct functioning. You can visually check
whether all characters are displayed
properly on the display.

Four different test screens will appear, each
of which will need to be confirmed by
pressing any front panel key.

When the test is finished, you will
automatically be taken back to the menu
view.

Keys

Starts the key test.

Press Enter to start the key test.

Perform this test to check the keys for
correct functioning.

You will be prompted to press specific keys,
whereupon you should press the respective
key.

In case one key is defective, you may exit
the test using the other keys.

When the test is finished, you will
automatically be taken back to the menu
view.

Alarm

Sets the alarm output.

Sets the alarm output and turns on the
alarm LED.

The letters AL will appear in the upper right
corner of the display, indicating that an
alarm was triggered. AL will continue to
flash until the alarm is either switched off
or acknowledged automatically.

Perform this test to check the alarm output
for correct functioning.