2N StarPoint manual - Manual (Page 47)

47
Push the function button during a call. The call will be put on hold and you will hear the
dialtone and can dial another station number. The opponent will hear music. Having set
up the other call, you can push the same button to switch the calls.
HandsFree/Speakerphone
Use this function to make HandsFree calls. Some terminals are not equipped with an
external microphone and cannot make full use of this function. For such terminals the
function is available. This function uses the standard handset Speakerphone
microphone instead of an external microphone and the call quality is usually lower.
Use:
If you push the button during an incoming call, you will answer the call in the
HandsFree mode, which is signalled by the button LED. Re–push the button to
terminate the call.
If you push the button during a call with your handset picked–up, the telephone
switches into the HandsFree mode too. This is signalled by the button LED. Now you
can hang up the handset without terminating the call.
Call Slot
Use the function to make multiple calls from one terminal by holding the previous call
and setting up a new call using another call slot. By default, each terminal has three
call slots.
Use:
Push the unused ("switched–off") call slot button during a call. The active call will be
put on hold as with the Flash function, you will hear the dialtone and the held user will
hear pre–defined music. If there are more calls in your terminal call slots, you can
switch them using the respective call slot buttons. The active call slot LED is shining
while the held call slot LED is flashing. The unused call slot LED is off.
Intercom
Intercom is a special type of call where a predefined telephone number is dialled by
pressing the Intercom function button and the called station receives the call
automatically in the HandsFree mode. The function is suitable for flexible
communication – you can speak the moment you push the button.
The Intercom function works with the telephones 2N StarPoint 500
®
only; if a different telephone type is used, the call is not answered
automatically.
Use:
Press and keep pressed the button with the Intercom function. Start speaking when
you hear a beep. The called user answers the call automatically in the HandsFree
mode. The called party gets an acoustic signal before the call. Keep the button pressed
during the whole call. Release the button to terminate the connection.