2N BRI Lite/Enterprise v1.1 - Manual (Page 77)

77
CLIP routing table + CallBack
Use the table to set a fixed CLIP assignment of incoming CLIPs from GSM to the
numbers of extensions to which incoming calls are routed automatically. Also, set
the CLIP list in the GSM network for which CallBack is enabled.
 GSM number (CLIP) – user Id in GSM/UMTS.
 Autodial – enable/disable CLIP routing for the selected CLIP.
 Dial to VoIP – VoIP destination number for the CLIP routing function.
 Auto CallBack - enable/disable CallBack routing for the selected CLIP.
 Limit – set the maximum call duration (minutes).
Note
 Remember to activate the CallBack mode in the GSM incoming groups
for a proper function.
Mobility Extension
Use this table to register the Mobility Extension users.
 Name – user name for calling to VoIP.
 User – registration user name for VoIP.
 Password – registration user password for VoIP.
 GSM number (CLIP) – user SIM card CLIP.
 Follow me function - enable/disable call forwarding to the user mobile station
(according to CLIP).
 SMS at no answer function - enable/disable sending of SMS on missed calls.
Ethernet configuration
Use this window to set the gateway Ethernet interface.
 Use DHCP - enable/disable the DHCP client function for 2N BRI gateway.
 IP address - fixed IP address (v4) for the 2N BRI gateway Ethernet interface.
 Subnet mask – network mask for the 2N BRI gateway Ethernet interface.
 Default gateway - IP address (v4) of the IP gateway in the Ethernet.
Caution
 Saving wrong values, e.g. DHCP enable, may result in making the 2N BRI
gateway configuration part inaccessible. In that case, reset the GSM
gateway to factory values; refer to Subs.4.1, page 49.
Tip
 If the gateway is in the DHCP client mode, the current values obtained
from the DHCP server are displayed in the IP address, Subnet mask and
Default gateway items.