2N BRI Lite/Enterprise v1.1 - Manual (Page 71)

71
Note
 The INVITE message must contain the called and calling numbers in order
that the SMS at no answer function may work properly.
 Delay for ALERTING [a] – set the delay before sending the ALERTING
message.
 Minute parameter – define whether the GSM gateway shall consider call
duration or count while limiting outgoing calls.
 Day of deleting statistics in group (every month) – set a day on which statistic
data on disconnected calls shall be deleted.
 Generate virtual ring tone – enable/disable generation of the virtual ringing
tone into the VoIP interface.
 Call length counting – define whether call minutes or seconds shall be
counted.
 BTS lock – identify the BTS to which the GSM modules shall log in. Restart the
selected GSM modules to execute the changes.
Caution
 The BTS lock service work with specific GSM modules only (Q55)!
 If you set a wrong BTS lock, the selected GSM module(s) will not log in to
GSM.
 After call relax delay – set the time between the end of the current call and
start of the next call via one and the same GSM/UMTS module. The
recommended value for heavy-traffic installations is 2 seconds!
 Add random time – use this auxiliary parameter to add random time in
seconds. Thus, the resultant time is the sum of the two above mentioned
parameters.
Disconnect call
Set the reasons for immediate discontinuation of an outgoing call to GSM/UMTS.
Send CLIP from VoIP to GSM/UMTS
 Transfer CLIP to GSM/UMTS – enable/disable the function.
 Separating char – define the CDN/CLIP separating character.
 Modify („-‟ remove one digit) – change the CLIP. The „-‟ character is used for
deleting one character from the left.
Caution
 The Send CLIP from VoIP to GSM service must be supported by the
GSM/UMTS provider‟s network. Otherwise, the call may be rejected by
GSM/UMTS!
Basic settings
 Roaming enabled for network code – international code for the roaming
enabled network. The code consists of the following two numbers: