2N BRI Lite/Enterprise v1.7 - Manual (Page 41)

41
2N TELEKOMUNIKACE a.s., www.2n.cz
®
4.1 Ethernet Interface
The BRI gateway can be fully configured via the web interface at
. Make sure that a device equipped with a web browser (PC, http://IP_gateway_address
NB, Tablet, etc.) has been connected for successful connection to the BRI gateway
configuration interface. The device also supports configuration via an extended AT
command set on the Telnet interface (IP port 23).
The BRI gateway supports DHCP (client). By default, the DHCP support is disabled.
Use the web configuration interface in the Gateway configuration – Ethernet
section to set the Ethernet interface. configuration
Ethernet Interface Factory Settings
IPv4 address 192.168.1.2
IP mask 255.255.255.0
Gateway 192.168.1.1
User name Admin
User password 2n
Tip
The device also supports configuration via an extended AT command set
on the Telnet interface (IP port 23). Refer to
, page for details. Subs. 6
Tip
If DHCP is active, use specialised detection software (for LANs only) to
identify the assigned IP address. Refer to the
web sites, BRI www.2n.cz
Gateways (IP Scanner) for the software.
Caution
Change the user name and password during your gateway first
configuration to avoid unauthorised access to your gateway configuration!
Refer to page for details!
Tip
In the event of data loss or configuration interface unavailability, perform
the factory reset to retrieve the data. Doing so, however, you reset all the
default values in your gateway. Refer to
, p. for details. Subs. 4.4