Isdn settings – 2N BRI Lite/Enterprise v1.7 User Manual
Page 100
100
ISDN Settings
%I00=xxx – pri1 protocol/mode:
NT,TE,NT/S,NTNT (pri2 = TE,NT,SY,NT)
For FW:2_03_15 only NT and NT/S (sync received from TE port)
%I01=tei,mtp tei,mtp = 0..63,0 – .fixed tei,ptp
tei,mtp = 64,0 – .dynamic tei,ptp
tei,mtp = 64,1 – .fixed tei,mtp
%I05=c1,c2,c3,c4 – cause codes for failed calls
c1=dial timeout (TIMEOUT=120)
c2=dis.prefix (REJECT=21)
c3=req.mod/grp not ready (TEMPFAIL=41)
c4=pref grps not ready (CONGEST=42)
%I06=sack,proc,prog,ale – prog.elem (0=off,1..8) for isdn message
%I07=opx/npx – list of old/new prefixes (max 47 chars)
%I08=dial,ring,disc – dial (0 = off,1..255) dialtone to NT on empty SETUP,
ring (0=off,1 ..255) ringtone to NT if no PROGRESS from PSTN
1=EU (dial = constantly 425Hz,ring = 1000+4000msec 425Hz)
2=CZ (dial = 300/300/600/1200msec 425Hz,ring = 1000+4000msec
425Hz)
3=HU (dial = constantly 425Hz,ring = 1000+4000msec 425Hz)
4=GB (dial = constantly 425Hz,ring = 400+200+400+2000msec
400+450Hz)
disc(0=off,1..255) busy tone to NT interface on DISCONNEECT
%I09=day,bits,enb – day (0=off,1..31) of clearing pri stat
ctrl bits (b0=not defined, b1=not defined ,b2=subaddr–recv, b4=don't
send CONNECT_ACK in TE mode)
enblock digits (0=overlap,1..20)
%I11=xxx – dial for dig.call from pri1 (max 15 chars)
%I21=xxx – dial for dig.call from pri2 (max 15 chars)
%I127=msn – MSN number for TE mode
%i28=pin (max 15chars) – PIN (password) for TE–>GSM calls