Sim card inserting/removing – 2N BRI Lite/Enterprise v1.7 User Manual
Page 18
18
No strong electromagnetic radiation is allowed on the 2N BRI Enterprise /
®
installation site.
BRI Lite
No strong electromagnetic reflections are allowed on the 2N BRI Enterprise /
®
antenna installation site.
BRI Lite
An inappropriate location of
or its antenna
2N BRI Enterprise / BRI Lite
®
close to television, broadcasting and/or other rf-sensitive sets may impair the
function of these sets.
Being a source of radio frequency emissions, the 2N BRI Enterprise / BRI
®
antenna should not occur in the close vicinity of the human body. The health
Lite
hazard is higher than with mobile phones as, generally, gateways shared by
multiple users show a very high traffic.
It is recommended that the power supply adapter should be connected to a
network with a UPS back-up and due overvoltage protection.
SIM Card Inserting/Removing
Insert the SIM card in the
bottom as shown in the
2N BRI Enterprise / BRI Lite
®
figure. As the SIM slots are of the Push/Pull type, just slide the card in and push it into
position. Push the SIM gently to slide it out of the slot.
Caution
Be sure to
such provider/SIM card services as call forwarding, call
set
barring, preferred networks, SMS centre, etc. in your mobile phone
into
.
before inserting the SIM card
2N BRI Enterprise / BRI Lite
®
If two SIM cards are used, make sure that both the SIM cards have one
or
.
and the same PIN
PIN code request disable
Having inserted the SIM card, restart 2N BRI Enterprise / BRI
®
to make the SIM card log in.
Lite
Remember to
the
service before using the
disable
Another call on line
SIM cards!