1 configuration, Ip address retrieval – 2N Helios IP Force User Manual
Page 49
49
3.1 Configuration
Use a PC equipped with any web browser to configure
:
2N
®
Helios IP Force
Launch your web browser (Internet Explorer, Firefox, etc.).
Enter the IP address of your intercom (http://192.168.1.100/, e.g.).
Log in using the
user name and
password.
Admin
2n
You have to know the IP address of your device to log in to the integrated web server.
By default,
is switched into the dynamic IP address mode, i.e. it
2N
®
Helios IP Force
obtains the IP address automatically if a properly set DHCP server is available in your
LAN. If no such DHCP server is available, you can operate
in the
2N
®
Helios IP Force
static IP address mode.
If your device remains inaccessible (you have forgotten the IP address, or the LAN
configuration has changed, for example), change the LAN settings using the buttons on
the device.
IP Address Retrieval
Take the following steps to retrieve the
IP address:
2N
®
Helios IP Force
Connect (or, if connected, disconnect and reconnect)
to
2N
®
Helios IP Force
the power supply.
Wait for the second sound signal
.
Press the first quick dial button 5 times.
2N
®
Helios IP Force will read its IP address.
If the address is 0.0.0.0, it means that the intercom has not obtained the IP
address from the DHCP server.
Note
Be sure to press the button sequence within thirty seconds after the
sound signal for security reasons. Up to 2 s intervals are allowed between
the presses.