Internal rfid card reader 13.56 mhz, Function, Specifications – 2N Helios IP Force User Manual
Page 36
36
Internal RFID Card Reader 13.56 MHz
The
(Part No. 9151016) is used for reading
Internal RFID Card Reader 13.56 MHz
RFID card Ids in the 13.56 MHz band. This module is intended for mounting into the
model 9151102CR, 9151102R, 9151101CRP and 9151101RP.
2N
®
Helios IP Force
These models have an window, which is necessary for antenna operation. If
the Internal RFID Card Reader is installed, it is not possible to install the Additional
Switch.
Function:
The
Internal RFID Card Reader adds one logical input, two
2N
®
Helios IP Force
additional switches and a tamper switch to the
basic unit.
2N
®
Helios IP Force
The purpose of the tamper switch is to signal any unauthorised opening of the intercom
(to prevent a theft, e.g.). It is recommended to use the tamper switch.
Specifications:
Card reader
Operating frequency: 13.56 MHz
Minimum reading distance: 30 mm above
cover
2N
®
Helios IP Force
Compatible with cards
ISO14443A - Mifare Classic 1k & 4k, DESFire EV1, Mini, Plus S&X,
SmartMX, Ultralight, Ultralight C, SLE44R35, my-d move (SLE66Rxx),
PayPass, Legic Advant
ISO1443B - Calypso, CEPAS, Moneo, SRI512, SRT512, SRI4K, SRIX4K,
PicoPass, HID iCLASS
ISO18092/NFC - NFCIP-1: Active and passive communication mode, NFC
Forum Tag Type 1–4, Sony FeliCa
Relay output
Switching contact
30 V / 2A AC/DC
Active output
9 to 12 V / 700 mA transistor switched output. Depends on power supply.
Logical inputs
Active mode – requires external voltage (JP2 jumper OFF)
U
-ON = min +2.5 V
IN
U
-OFF = max +1.5 V
IN
U
max = +48 V
IN
I
(U
+48 V) = max 1 mA
IN
IN