2N Helios IP Force - Manual (Page 43)

43
2N TELEKOMUNIKACE a.s., www.2n.cz
®
The device also supports a Departure button connected between the ‘PB’ and ‘-
HeliosIP’ terminals. Press the Departure button to activate the output for 5 seconds.
Status signalling:
Green LED Red LED Status
blinking off Operational mode
on off Activated output
blinking blinking Programming mode – waiting for initialisation
on blinking Error - wrong code received
Configuration:
Connect the to the properly set intercom switch 2N Helios IP Security Relay
®
output; refer to the . Make sure that one 2N Helios IP Configuration Manual
®
LED at least on the is on or blinking. 2N Helios IP Security Relay
®
Press and hold the Reset button for 5 seconds to 2N Helios IP Security Relay
®
put the device in the programming mode (both the red and green LEDs are
blinking).
Activate the intercom switch using the keypad, telephone, etc. The first code sent
from the intercom will be stored in the memory and considered valid. After code
initialisation, the
will pass into the operational 2N Helios IP Security Relay
®
mode (the green LED is blinking).
Connection:
Wiegand Isolator
The (Part No. 9159011) is usef for galvanic isolation of the Wiegand Isolator
Wiegand bus.