Ethernet configuration, Login configuration, Web configuration – 2N StarGate/BlueTower v5.5 User Manual
Page 88
88
Ethernet Configuration
This window helps you configure the Ethernet interface of your gateway.
Use DHCP – enable/disable the DHCP client function in 2N
StarGate /
®
.
BlueTower
IP address – the fixed IP address (v4) of the 2N
StarGate / BlueTower
®
Ethernet interface.
Subnet mask – the subnet mask for the
Ethernet
2N
StarGate / BlueTower
®
interface.
Default gateway – The IP gateway IP address (v4) in the Ethernet network.
– primary DNS server.
DNS server1
– secondary DNS server. Used as a back-up when DNS server 1 is
DNS server2
not functional.
Login Configuration
The window helps you set the access password and name for the 2N
StarGate /
®
web interface. Use the same data for Telnet connection too.
BlueTower
Web Configuration
Set additional parameters for the gateway web interface.
Auto logout – set the count of minutes in which the current user should be
logged out automatically.
Enable web session lock – by default, one Admin user may only be connected
to the GSM gateway at a moment. If another authorised user tries to log in, the
Note
Remember to activate the CallBack mode in the GSM incoming groups
for a proper function.
The maximum count of CLIP routing table records is 96.
Caution
Incorrect settings, e.g. enabling the
, may result in a
DHCP client service
denial of access to the
configuration. To
2N
StarGate / BlueTower
®
avoid this, restore the GSM gateway default settings. Refer to Subs.
for details Jumper pro default.
Tip
In case the gateway is in the DHCP client mode, current assignments
obtained from the DHCP server are displayed in the IP address, Subnet
and Default gateway items.
mask
Caution
Remember to change the username and password during the first
gateway configuration to avoid unauthorised access!