2N StarGate/BlueTower v5.5 User Manual

Page 86

Prefix List 1–8

Eight prefix groups to be assigned in the LCR table.

Basic Settings

GSM network ID – set the prefix list user code for easier orientation in the LCR.
Default count of digits – default length of the number to be dialled into the
GSM/UMTS networks for routing via the selected prefix list. Use this parameter in
case the Digits count is not included in the Accepted prefixes table.

Table of Replaced Prefixes

Use this table to replace the prefix of the received number (‘00’ with ‘+’, e.g.). You can
only add or remove the prefix. This change is made before the prefix is searched for in
the prefix table. Be sure to keep the „/“ record in the table for a proper function.

Table of Accepted Prefixes

List of prefixes of called destinations to which the selected prefix list applies.

Prefix Change for PRI 1 to PRI 2 Calls

A table of prefixes to be replaced in the case of PRI 1 to PRI 2 outgoing calls.

Note

The number to be dialled to the GSM/UMTS network must meet the

condition.

Count of digits
For

calls, the count of digits to be dialled must be equal to or higher

VoIP

than the value set in the

Count of digits

For GSM/UMTS calls by overlap dialling via the

interface, the

PRI NT/TE

defines the maximum count of the digits to be dialled.

Count of digits
For GSM/UMTS calls by block dialling via the

interface, the

PRI NT/TE

is ignored.

Count of digits

Note

The maximum count of records in the

is 14

Table of replaced prefixes

for each prefixlist.

The maximum table record size is 9 characters for the prefix and 9
characters for the replaced number.

Note

The maximum count of records in the

is 138

Table of accepted prefixes

for each prefixlist.

The maximum table record size is 9 characters.