2N Helios IP User manual, 1510 v1.13 - Manual (Page 104)

Configuration 3.3
104
1*XXXXXXX ‘1’ is the external USB RFID card reader format (Part No.
9137420E).
Configuration with External RFID Card Reader
To facilitate entering card ID codes into 2N ® Helios IP, we recommend you to order an
external RFID card reader (Part No. 9137420E), which can be connected to your PC
via a USB interface. Enter the card ID into 2N
® Helios IP using the web interface as
follows:
Enter 1* (ID type) into the card ID field and leave the cursor behind the asterisk. The
card reader behaves as a keyboard connected to your PC and, when the card is
applied, writes the card ID code into the rest of the field automatically.
Configuration without External RFID Card Reader
No external card reader is needed in some simple 2N ® Helios IP installations for few
users. To add an ID code, just apply the new card to 2N ® Helios IP and copy its ID
displayed in the Access Log (RFID Card Reader – Access Log) into the respective field.
Make sure that you have installed the right card.
Use of RFID Card Reader Module Relay
The card reader module is equipped with two relays for various purposes such as
switching of other electronic locks, lighting, etc. Set these relays to Reader switch
#1 or Reader switch #2 in the Lock section of the Lock setting menu.