2N Analogue UMTS gateway 2N EasyGate UMTS USB - User Manual, v1.00 User Manual

Page 27

Ringing signal – cadence DATA/Fax

Function No.:

This setting doesn’t influence EasyGate UMTS Data. EasyGate UMTS Data
doesn’t support Data/Fax calls.

CLIP

Function No.:

Set this item to enable/disable identification of a telephone line calling from a
GSM network. The function can be enabled if you have a device on your
telephone line that is capable of receiving FSK according to ETSI standards.
Setting options:

Disable

-EasyGate does not transmit the CLI.

FSK during ringing -EasyGate transmits the FSK-based CLI according to the

ETSI EN 300 659 standard (transmission during ringing).

Tbd.

- prepared for future use

Default setting: Disable

Replace character + in CLI by

Function No.:

If this parameter is filled, the + character in the international prefix of CLI is
replaced by the defined string. The + character can neither be transmitted by the
FSK protocol nor dialed by the DTMF from a terminal.

Setting options: 0-15 characters (0-9,*,#)
Default setting: blank

8.3.1.6 Automatic call

BabyCall number

Function No.:

A number to be dialed for the automatic call function. If this item is blank, the
function is disabled.

Setting options: 0-15 characters (0-9,*,#,+)
Default setting: blank

BabyCall timeout [s]

Function No.:

Time between line Off-Hook and automatic call beginning (if enabled). During this
timeout EasyGate waits for dialing that cancels the automatic call. You can make
standard call if the BabyCall function is enabled.
Setting options: 0-15 s
Setting step:

1 s

Default setting: 0 s