Brother Fax Machine/Multi-Function Center MFC-9125CN - Manual (Page 162)

146
Drum Error The corona wire on the drum unit
needs to be cleaned. Clean the corona wire on the drum unit. (See
Cleaning the corona wires on page 160.)
It is time to replace the drum
units. Replace the drum unit with a new one for the
color that is indicated on the LCD. (See
Replacing the drum units on page 177.)
Drums End Soon The drum unit is near the end of
its life. Buy new drum units before you get a
Replace Drums message.
Drum End Soon(X)
1 The drum unit for the color
indicated on the LCD is near the
end of its life. Buy new drum unit for the color indicated on
the LCD before you get a
Replace Drum(X)
1
message.
Fuser Error The temperature of fuser unit
does not rise at a specified
temperature within specified time. Turn the power switch off, wait a few
seconds, and then turn it on again. Leave the
machine for 15 minutes with the power on.
The machine can be turned off for
approximately 60 hours without losing faxes
stored in the memory. (See Transferring your
faxes or Fax Journal report on page 150.)
The fuser unit is too hot.
Init Unable XX The machine has a mechanical
problem.  Disconnect the machine from the power
for several minutes, then reconnect it.
(The machine can be turned off for
approximately 60 hours without losing
faxes stored in the memory. See
Transferring your faxes or Fax Journal
report on page 150.)
 If the problem continues, call Brother
Customer Service.
Jam Inside The paper is jammed inside the
machine. (See Paper jams on page 152.)
Jam Rear The paper is jammed in the back
of the machine. (See Paper jams on page 152.)
Jam Tray The paper is jammed in the paper
tray of the machine. (See Paper jams on page 152.)
No Belt Unit The belt unit is not installed
properly. Re-install the belt unit. (See Replacing the
belt unit on page 181.)
No Paper The machine is out of paper or
paper is not properly loaded in the
paper tray. Do one of the following:
 Refill the paper in the paper tray and
press Black Start or Color Start or put
the paper in the manual feed slot.
 Remove the paper and load it again.
Then press Black Start or Color Start.
 If the problem is not solved, the paper
pick-up roller may be stained. Clean the
paper pickup roller. (See Cleaning the
paper pick-up rollers on page 166.)
Error Message Cause Action