JLG G9-43A (9151-4003) Operator Manual - Manual (Page 20)

2.8
8060-3037-A
PINCH POINT
KEEP OUT
REACHING INTO BOOM
HOLES AND OTHER PINCH
POINTS CAN CAUSE
SERIOUS INJURY
OR DEATH.
Located on boom
S/N 0193001 thru 0160000668
P/N 8060-3037
DECALS
9114-3284
LEAD ACID BATTERIES PRODUCE FLAMABLE AND
EXPLOSIVE GASSES
WHEN CHECKING, TESTING, USING
BOOSTER BATTERY OR CHARGING BATTERIES:
* DO NOT USE SMOKING MATERIALS NEAR BATTERIES
* KEEP FLAMES AND SPARKS AWAY FROM BATTERIES
* WEAR SAFETY GLASSES
* ASSURE BATTERY IS NOT FROZEN AND ELECTROLYTE
IS AT PROPER LEVEL IN EACH CELL
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD
RESULT IN SERIOUS INJURY OR DAMAGE TO THE
ELECTRICAL SYSTEM
Located on frame below engine cover
S/N 0193001 thru 0160000668
P/N 9114-3284
9150-3099 REV -
K e e p s p a r k s , f l a m e s a n d l i g h t e d
m a t e r i a l s a w a y f r o m b a t t e r i e s .
B a t t e r i e s p r o d u c e E X P L O S I V E
G A S E S . E X P L O S I O N c o u l d
r e s u l t i n s e r i o u s i n j u r y.
Located on underside of engine cover
S/N 0160000683 thru Current
P/N 9150-3099
9114-3285
WHEN JUMP STARTING MATERIAL HANDLER
* NEVER ALLOW VEHICLES TO TOUCH
* CONNECT THE POSITIVE (+) JUMPER CABLE TO
POSITIVE (+) POST OF DISCHARGED BATTERY
* CONNECT OPPOSITE END OF POSITIVE (+) JUMPER
CABLE TO POSITIVE (+) POST OF BOOSTER BATTERY
* CONNECT THE NEGATIVE (-) JUMPER CABLE TO
NEGATIVE (-) POST ON BOOSTER BATTERY
* CONNECT OPPOSITE END OF NEGATIVE (-) JUMPER
CABLE TO GROUND POINT ON MACHINE AWAY FROM
DISCHARGED BATTERY
* FOLLOW STANDARD STARTING PROCEDURES
* REMOVE CABLES IN REVERSE ORDER AFTER MACHINE
HAS STARTED
JUMP STARTING INSTRUCTIONS
Located on frame below engine cover
S/N 0193001 thru 0160000668
P/N 9114-3285
8060-3026
COOLING SYSTEM
IS PRESSURIZED.
REMOVE CAP SLOWLY.
HOT FLUID CAN
CAUSE BURNS.
Located on radiator
S/N 0193001 thru 0160000668
P/N 8060-3026
MOVING PARTS could cut or crush causing
death or serious injury. Keep clear of
moving parts while engine is running.
9151-3210 REV -
Located on boom
S/N 0160000683 thru Current
P/N 9151-3210
9114-3290
ATTACHMENT MUST BE SECURED TO MACHINE.
CHECK TO ASSURE QUICK SWITCH PLUNGER
PIN IS FULLY ENGAGED AND LOCKED AFTER
ATTACHMENT CHANGE.
IF PLUNGER PIN IS NOT FULLY ENGAGED
AND LOCKED ATTACHMENT MAY FALL OFF
CAUSING SERIOUS INJURY OR DEATH.
Located on boom head
S/N 0193001 thru 0160000668
P/N 9114-3290
9114-3282
STAY CLEAR OF PINCH POINT AREA
ANYTIME ENGINE IS RUNNING.
BEING IN PINCH POINT AREA COULD
CAUSE SERIOUS INJURY OR DEATH.
Located on boom head
P/N 9114-3282