JLG G9-43A (9151-4003) Operator Manual - Manual (Page 18)

8060-3022
AVOID HIGH VOLTAGE LINES.
IT IS UNLAWFUL TO PLACE
ANY PART OF THIS MACHINE
OR LOAD WITHIN 10 FEET
OF HIGH VOLTAGE LINES
UP TO 50,000 VOLTS.
DEATH OR INJURY MAY
RESULT FROM CONTACTING
ELECTRIC LINES.
9114-3283
NO RIDERS PERMITTED ON HANDLER.
OPERATOR ONLY IN MACHINE
WHILE RUNNING.
RIDERS COULD FALL OFF MACHINE
CAUSING SERIOUS INJURY OR DEATH.
Located on cab fender
S/N 0193001 thru 0160000668
P/N 8060-3022
Located on left cab wall
S/N 0193001 thru 0160000668
P/N 9114-3283
Located on mud guard
S/N 0193001 thru 0160000668
P/N 9055-3027
9055-3027 REV. A
READ AND UNDERSTAND THE FOLLOWING PRIOR TO LIFTING PERSONNEL.
WHEN LIFTING PERSONNEL USE ONLY A GRADALL MANUFACTURED PERSONNEL WORK PLATFORM.
DO NOT DRIVE MACHINE WITH PERSONNEL IN PLATFORM.
WHEN PERSONNEL ARE IN PLATFORM REMAIN SEATED IN CAB WITH PERSONNEL
IN DIRECT LINE OF SIGHT.
OPERATE CONTROLS LIGHTLY AND CAUTIOUSLY WHEN LIFTING PERSONNEL.
READ AND UNDERSTAND PERSONNEL WORK PLATFORM USER'S MANUAL BEFORE LIFTING PERSONNEL.
DO NOT USE PERSONNEL WORK PLATFORM WITHOUT THE PROPER GRADALL MATERIAL
HANDLER/PERSONNEL WORK PLATFORM CAPACITY CHART DISPLAYED IN CAB.
FAILURE TO COMPLY COULD RESULT IN SERIOUS INJURY OR DEATH.
2.6
DECALS
R
7733-3027
Located on left cab wall
P/N 7733-3027
CONTACTING ELECTRIC POWER
L I N E S w i l l r e s u l t i n d e a t h
o r s e r i o u s i n j u r y.
D o n o t p l a c e m a c h i n e o r l o a d
w i t h i n 1 0 f e e t ( 3 m ) o f e l e c t r i c
9150-3110 REV - A
p o w e r l i n e s .
10 FT.
(3 M)
Located on right cab wall
S/N 0160000683 thru Current
P/N 9150-3110
9150-3109 REV -
N O R I D E R S . R i d e r s c o u l d FA L L O F F
m a c h i n e c a u s i n g d e a t h o r s e r i o u s i n j u r y.
Located on left cab wall
S/N 0160000683 thru Current
P/N 9150-3109
9151-3208 REV -
When lifting personnel, USE ONLY a Gradall manufactured
personnel work platform, with proper personnel work
platform CAPACITY CHART DISPLAYED in cab.
READ AND UNDERSTAND personnel work platform Owner/Operator
manual before lifting personnel.
DO NOT DRIVE machine from cab when personnel are on platform.
All personnel on platform must WEAR A FULL BODY HARNESS,
with lanyard attached to a designated anchorage point.
When personnel are on platform, the OPERATOR MUST REMAIN
SEATED in cab with personnel in direct line of sight.
OPERATE CONTROLS CAUTIOUSLY and lightly when lifting or
positioning personnel.
Failure to comply could result in death or serious injury.
Located on right cab wall & boom head
S/N 0160000683 thru Current
P/N 9151-3208
Located on frame below engine cover
S/N 0193001 thru 0160000668
P/N 9108-3492