JLG 660SJ ANSI Service Manual - Manual (Page 171)

SECTION 5 - HYDRAULICS
3120718 – JLG Lift – 5-5
Assembly
NOTE: Prior to cylinder assembly, ensure that the proper
cylinder seal kit is used. See your JLG Parts Manual.
Apply a light film of hydraulic oil to all components prior to
assembly.
1. A special tool is used to install a new rod seal into
the applicable cylinder head gland groove.
WHEN INSTALLING ‘POLY-PAK’ PISTON SEALS, ENSURE SEALS
ARE INSTALLED PROPERLY. REFER TO WIPER SEAL INSTALLA-
TION FOR CORRECT SEAL ORIENTATION. IMPROPER SEAL
INSTALLATION COULD RESULT IN CYLINDER LEAKAGE AND
IMPROPER CYLINDER OPERATION.
WHEN INSTALLING THE WIPER SEAL ON THE LOWER (TOWER)
LIFT CYLINDER, APPLY LOCTITE #609 ON THE WIPER SEAL IN
THREE EVENLY SPACED PLACES TO AID IN RETENTION OF THE
SEAL.
2. Use a soft mallet to tap a new wiper seal into the
applicable cylinder head gland groove. Install a new
wear ring into the applicable cylinder head gland
groove.
3. Place a new “o”ring and back-up seal in the applica-
ble outside diameter groove of the cylinder head.
Figure 5-6. Rod Seal Installation
Figure 5-7. Poly-Pak Piston Seal Installation
Figure 5-8. Wiper Seal Installation
Figure 5-9. Installation of Head Seal Kit